Z Flashing For Panel Siding

The z flashing is used as a horizontal joint between 7 16 inch siding to keep moisture out.

Z flashing for panel siding.

Window and door cap 1 25 in x 120 in x 1 56 in aluminum z flashing. Test the rotted area of the t1 11 siding by poking it with a nail or a screwdriver. The seat dimension 5 8 in. Description documents this aluminum z flashing is used at panel intersections and other vertical surfaces when stacking two courses of panels without an overlap.

It is used to protect the horizontal joints between sheets of siding from water infiltration. Quality edge z flashing is available in colors that match the drip edge w valley and gutter protection. The large leg of the metal goes against the wall leaving the seat and face covering the top edge of the siding. It s commonly used on a gable or eave wall where a seamless application is impossible due to wall height.

Galvanized steel z flashing is made from professional 31 gauge galvanized steel. If only the surface is damaged. The seat dimension 3 8 in corresponds to the siding thickness. Install the first length of z flashing.

Corresponds to the siding thickness. It is used where siding meets horizontally. Scrape loose paint off the rotted area with a putty knife and use 80 grit sandpaper to smooth the rough surface if. Galvanized steel z flashing is made from 28 gauge galvanized steel.

The large leg of the metal goes against the wall leaving the seat and face covering the top edge of the siding. Product details sku s specs colors dimensions. Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall stud. Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.

It is used to protect the horizontal joints between sheets of siding from water infiltration.